4. Piston sleeve and piston bottom must be loosened by taking out 6 hex, screws. Now remove piston rod, guide tube and spring. time to time because its condition is responsible for the lifting capacity of the cylinder. 5. Clean all parts, renew unserviceable ones. 6. Reassembling is done vice-versa. The cylinder inside, during reassembly, is coated with an acid free grease. When inserting the piston sleeve, do not damage the edges of same. Remark: The piston sleeve should be replaced from C.
Remove, install and repair rear power lift arms a Fortype4Ol b For type 411 Picture 55-3/4 Picture 55-3/5 Picture represents the not yet reenforced system with removed loading platform = Breather filter 1. Remove rear wall and inserted floor. 2. Remove both cylinders in forward direc 1. Remove loading platform. 2. Remove air line. tion after removing the hex. screws on the mounting bracket. 3. Decotter connection pin for lifting linkage on fork head and push power lift arms into upwards position. 3. Installation is done vice-versa. Remark: 4 4 h h h i f h 2010/3/02100/52 li d