mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

II. Repair rotary valve 1. Place valve into vise. Bottom side pointing upwards. Remove the 4 head screws, care 4. Reassembly is donevice-versa,coatall sliding parts with grease before reassembling. fully take off lower part. Now remove sealing ring, rotary spool, both cylindrical rollers, pressure piece and springs as well as operating spindle. 2. Check the remaining grooved ring in the housing upper part, if necessary renew. 3. Remove strainer screw on upper part, clean strainer. Remove both same in lower part look out for seals, clean strainers. Unscrew, out of lower part, the threaded ring and clean the strainer and small filter beeing underneath. Picture 55-3/2 Rotary valve dismounted B.

Remove, install and repair the front power lift arm place lever in cab into position "down’ 1. Disconnect tube line connection. 3. Remove mounting screws on mounting bracket, lift out cylinder. 2. If an implement is still mounted in front, remove the pin of the fork head. A. Installation into the vehicle is done vice- versa. I. Repair front mounted lifting cylinder