55-3 Pneumatic Power Lift System up to Type 411 a up to chass. no. 411.112.017 844 A. Rotary slide valve, remove, install and repair on the different outlets. Place operating Remark: Release the pressure in the system. lever in the respective positions and check 1. Disconnect the 3 tube connections. for max. pressure. On the free connections and on the breather hole, no air should escape. 2. Remove pin from linkage connection. Remark: New operating system for power lift system. 3. Remove the 4 mounting screws head screws on the angel and take off valve. As of chass. no. 411-75 027 53, the old type 4. Installation is done vice-versa. After the valve single valves.
This valves are mounted on rotary slide valve has be replaced by two is mounted back on again, only the pressure connection is connected. The housing and the transmission cover and the operating the outlets in middle position must be checked for leaks soapy water. After this, connect a check line with pressure gaue levers installed between driver seat and 4-wheel drive respectivly differential lock operating lever. See picture 55-3/1.