4. Installation is done vice-versa,the operating lever on the steering column must be in normal position resting position. II. Remove and install hydraulic cylinder 1. Disconnect hose lines on hydraulic cylinder quick couplings. 2. De-lock both pins on frame mounting bracket and mounting eye of shaft by taking out both M 8 screws with lock washers. 3. Remove both pins. Picture 55-2.1/3 4. Remove hydraulic cylinder. 1 = Return line to the tank 5. Reinstall vice-versa. 2 = Pressure line from tank 3 = Pressure connection f. coupl. rear 4 = Same as no. 3 5 = Pressure connection f. front impl. 6 = Same as no. 5 6.
Refill with hydraulic oil and do perform functioning test of the hydraulic operated power lifts. 7 = Operating valve f. rear power lift 8 = Operating valve for front power lift 10 = Fuse box 9 = Oil filler plug f. steering C. Oil storage tank with filter, remove and install 1. Drain hydraulic oil, look out for sealing ring. 5. Installation is done vice-versa. Watch guide pins on bottom of oil storage tank. 2. Disconnect hose lines. 6. Refill hydraulic oil. 3a Open cab Remove 2 hex, screws with lock rings on the cab and take off oil tank. Watch for spacer. Remark: Prior, remove air compressor with hydraulic pump for lack of space 4 hex screws M 8