Hydraulicly Operated Power Lift System as of Type 4Ua 55-2] as of chass. no. 411.112.017 845 A. Air compressor with gear type driven oil pump, remove and reinstall 1. Loosen tension mechanism on nir com pressor. Remark: After installation, the tensioning of V-belt must be checked and if necessary corrected. One should be able to depress the V-belt 5-8 mm. Recommended axle tension is 60 kp. 2. Remove V-belt. 3. Remove lines. 4. Remove the 4 hex. screws on base of com pressor, take out same with oil pump. 6. Fill up hydraulic oil to the upper mark of dip stick. Check markings on dip stick. Correct distance from dip stick mounting to top marking is 56 mm. 5. Installation is done vice-versa.
Picture 55-2.1/1 Hydraulic system in the engine compartment 1 = Oil tank 2 = Air compressor with oil pump 3 = V-belt tensioner 4 = Operating valve B. Double acting operating valve and hydraulic cylinder, remove and install