Repair Telescopic Cylinder of the Dump Bed 55-5 The following wear and tear parts can only be changed on a telescopic cylinder. b Remove stop-and pressure plate; further dismounting of the telescopic cylinders is not possible. A. Leaking swivel connection a Remove lock ring. b Take off swivel connection with the 2 lip rings. Picture 55-5/1. Remark: The lip rings must be coated with acid free grease before inserted. Sealing lip pointing to the inner side. The pinion edge should not be sharp or damaged for not to des troy the sealing lips when inserting the swivel connection. Formation of rust must be removed. B. Leaking floor plate On type 411, there are 2 executions. 1.
Execution with 0-ring in floor plate; up to telescopic cylinder Z 605 stamped on type designation plate of cylinder. Picture 55-5/2a. Picture 55-5/1 2 = Lip ring 1 = 5wivel connection house 3 = 5nap ring 2. Execution with 0-ring in cylinder sleeve: as of telescopic cylinder Z 605/65. Picture 55-5/2b. Remark: On type 421, only the 2nd execution is installed. a Remove snap ring. b Remove floor plate by hitting cylinder sleeve on a smooth wooden board. c Remove 0-ring. When reassembling, look out for: as per execution. .- 5 1. Execution: Install new 0-ring. Before installation, smoothen the rear edge of I 6 4