Hydraulic Pump with Air Compressor 55-6 I. Remove and install 1. Disconnect steel pipes and hose lines on oil pump and compressor. If necessary, check or change the spring. 2. Remove V-belt tension mechanism from bracket and take off V-belt. Spring data: Length, untensioned 213 mm Spring load 30 kp for each 100 mm spring travel. 3. Remove the 4 mounting bolts from base of compressor-oil pump, take out the unit. II. Repairing The air compressor is repaired as mentioned in section 42-10. 1. Disconnect hydraulic pump. Three balls are exposed which serve as a clutch of the air compressor resp. of the compressors bottom part. This balls must always be renewed when reassemble.
They should be inserted with grease into the groove of the pump shaft. Turn same, until it slides into the opposite part of the air compressor. Tighten mounting screws equally on pump flange. Picture 55-6/1 Dismounting of a hydraulic pump for pur pose of repairing is not allowed by the manufacturer. An exchange pump should aiwasbe available. There are complete com binations air compressor-oil pump of which the air compressor is an exchange unit. = Tension niechonsrn for V-belt 2 = 5wiveI point of mount. bracket 4. Installation is done vice-versa.