mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

Remove, Install and Partially Repair the Starter on Type 421 15-1 The starter is operated electrical via the glowplug starter switch on the dash board. If the starter fails to start, the reason for failure may be in the electrical system or in the starter itself. Loose terminals and bad ground connections may be the reasons for malfunctioning; the usual permissible loss of tension should not exceed more then 4 % in the cable going ta-and from the starter. The reaction of the switched-on head lights tell the condition of the battery and contacts of the starter. a Are the head lights going off, a bad connection is on the battery, on the cable connectors of the starter, or on any ground wire.

b Are the lights going off slowly, the battery is not charged, or damaged, or old. c If the lights of the head lights do not change at all, the starter needs a checking. A. Remove and install starter 1. Remove ground cable from battery. 4. Installation is done in vice-versa sequences. 2. Disconnect cable from starter. Coat pinion and pinion shaft with grease. 3. Remove starter from crankcase housing in forward direction. B. Repair starter partially Remark: If the starter fails to work, it is adviseable to have a service station check into it for to repair.

The repair instructions of the starter therefore deal only with an exchange of the carbon brushes and springs as well as changing of the starter pinion. a. 1. Remove collector protection ring. 2. Remove brushes. Picture 15-1/1. Picture 15-1/1 3. Place starter into vise, decotter castled nut of pinion shaft, remove nut with washer. 4. Remove pinion from shaft by turning anti