mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

Pre-Heating System 15-4 Check glow plugs To be able to have the complete glow system under control, same is equiped with a incandescent spiral. This spiral must get cheery red when the pie-heater switch is brought into position no. 1. If the spiral is getting glowing much brighter, the ground wire must be better connected an the glow wire, of a glow plug, on the glow plug indicator resistor or on the pie-heating resistance. If the spiral is not glowing at aM, a glow plug is out for order, mostly the glow plug wire is broken. To check which one, proceed as follows: shorten out all glow plugs one after one use screw driver and at same time bring starter switch in pos.

1, the one glow plug is out of order on which the glow plug indicator is starting to glow when the plug is shortened out. If the glow plugs are OK, check the glow plug indicator on dosh board or the glow plug indi cator resistor under the hood. As of installation of engine OM 615 chassis no. 421 . . .002229 the outer bus bars ore functioning as resistors. Therefore, no resistor in drivers cob. See Picture 15-4/1. Remove and install glow plugs 1. Remove ground cable terminal from battery. 2. Disconnect hot wire from plug no. 4 and ground cable from plug no. 1. 3. Remove nuts from plugs and also the current connecting rails with insulators. Unscrew glow plugs. Picture 15-4/1 Remark:

I = Outer bus bar acting as resistor 2 = Inner bus bar Before installing glow plugs again, check the glow plug channel with tool no. 636589035300 and if necessary clean