mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

20.9 Disassembling and assembling coolant pump 621 636 18 Install the sealing ring into the sealing ring 21 Screw in screw plug with new sealing ring into retainer. Press sealing ring retainer onto bearing the bearing housing. In so doing use a new gasket. Fill housing. the coolant pump with 10 ccm gear oil, then screw in bleed screw, which must upward in installed condi 19 Press hub so far on coolant pump shaft until it tion. touches the deep-groove ball bearing. Note: 20 Bolt coolant pump housing to bearing housing. New or replacement coolant pumps are not filled with In so doing use a new gasket. oil. 22 Check coolant pump on a test bench or on engine for leaks.

The coolant pump must neither lose coolant nor oil.