mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

Disassembling and assembling coolant pump 20.9 621 636 The coolant pump version on engine GM 621 has a io With the version on OM 621, press counter ring slide ring seal between bearing housing and impeller, into impeller with rubber 0-mg after lightly oiling The coolant pump version on engine OM 636 has a rubber 0-ring. collector ring gasket. The repair in both coolant pump version is the same by analogy. Note: Lapped side of counter ring must point upward toward slip ring gasket and must not be damaged Disassembly when pressing in. 11 Press sealing ring into bearing housing with 1 Unscrew coolant pump housing from bearing assembly sleeve. housing.

Beforehand, lightly coat outside of sealing ring and 2 Pulloffhuborbeltpulleyfromcoolantpumpshaft bare in bearing housing with oil. with extractor 112 589 07 33 00. To do so, the coolant pumpt shaft is held in a vice with the impeller. 12 On the version OM 621, press slip ring gasket 3 Pull the sealing ring retainer with an extractor off Coat bore of housing with oil beforehand. into bearing housing with suitable installer sleeve. the bearing housing. Then press the sealing ring out of the sealing ring retainer. 13 For version on OM 636 slip compression spring, cover, slip ring cage, sealing ring and slip ring onto the bearing housing.

After assembly, check whether the cover in properly seated on the sealing ring. If necessary push on with 5 Knock out both deep-groove ball bearings, the screwdriver. sealing ring and if necessary, the slide ring seal out of the bearing housing with a drift. 14 Slip housing over coolant pump shaft. 4 Press the coolant pump shaft with a drift out of shaft. 6 Slip slip ring, collector ring cage, pressure spring Caution! Do not damage sealing lips of sealing ring in and cover off coolant pump shaft with engine version so doing. GM 636.

15 When fitting coolant pump, do not damage slip 7 In the version on engine GM 621, force out only ring gasket, fit bearing housing with coolant pump if necessary, the counter ring with rubber 0-ring with shaft to self-made base ring. two suitable tools at the milled slot of the impeller. Then if necessary, force out coolant pump shaft out Fit deep-groove ball bearing onto shaft and press into of impeller with a drift, bearing housing with assembly sleeve. Clean and check all parts.

Check particulary the Lightly oil outside of bore of bearing housing and coolant pump shaft and the ball bearing as well as in deep-groove ball bearing so that the bearing slides version GM 621 the slide ring seal and the counter better when being pressed in. ring for wear. After pressing in the deep-groove ball bearing, check Note: that distande = 23 0.2 mm refer top. 1.1/3. Sealing rings, retaining rings and in version GM 636 the slip ring are always replaced. 16 Insert circlip on coolant pump shaft and fit spacer sleeve. Assembly