Removing and installing coolant pump 20.9 615 621 636 Removal and installation A. With engine OM 615 and OM 621 B. With engine OM 636 1 Drain coolant. If coolant contains additives, col- 1 Drain coolant. Collect in the case of antifreeze. lect coolant. 2 Remove v-belt. 2 Remove belt tensioner for air compressor. 3 Unscrew fastening bolts of the coolant pump at 3 Release upper radiator mount. the cylinder head. Remove coolant pump. Note gasket. 4 Unscrew bracket at the engine block. 4 Installation takes place in reverse sequence. 5 Release arid remove v-belt for fan drive. 5 Set v-belt to correct tension, i.
e., so that it can 6 Release tensioning device of the alternator and just be pressed with the thumb out of the straight remove. Values according to table on page 1.1/3. 7 Release both hose lines at pipe socket of coolant pump housing. 8 Unscrew slide ring seal. 9 Unscrew coolant pump three hexagon bolts. 10 Replace gasket and sealing ring between coo lant pump and crankcase. Before, thoroughly clean parting surface of sealing compound residues. 11 Installation takes place in reverse sequence. 12 Install the slide ring seal free of tension and use the two new sealing rings at the connections.
13 Fill with coolant, Run engine and check hose connections as well as flange connection of pump at engine block for leaks. Note: In order to determine whether the pump correctly works after installation, take closing cover at coolant filterpipe off with running warm engine. The flow must already be visible when engine is idling.