mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

Removing and installing coolant regulator 20.9 636 Removal and installation 1 Drain coolant. With antifreeze collect contents. Drain cock is at the lower coolant line. 2 Release hose clamp and hose of coolant line from reservoir to engine and remove. 3 Release union nut knurled nut and remove with the coolant regulator. Pay attention to rubber gasket which is in front of the bead of the coolant regulator. The arrow embossed on the coolant regulator must always point upward when installing, i. e. toward expansion tank. Coat union nut or threaded ring before the installation with grease. Note: Repairs cannot be made to the coolant regulator for example by exchanging the insert.

Unusable coolant regulators are to be replaced, recognizable from full opening in cold condition. A coolant regulator is best tested in a container with hot water in which a thermometer is immersed, The thermostat should begin to open at 80 °-13° and entirely open at 87 ° to 88 °. At the same time the valve should rise by 8mm. A pressure relief valve in the coolant expansion tank connection ensures an overpressure of 0.4 bar. Consequently the boiling temperature is increased at sea level from 1000 to 108 ° C. 4 Installation takes place in reverse sequence. 5 Fill with coolant. Run engine and check hose connections for leaks. If required, replace hose clamp and rubber hoses.