mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

Bleeding Brake System 42.3 Test Specifications, Storage and Shelf Life for Brake Components Test Specifications Note: In the interest of road safety, it is essential to give careful attention to checking and reconditioning the brake system. The brake system should therefore be examined at regular intervals. Scope of Inspection Work 1. Check brake shoes and brake pads/linings. 3. Check brake drums and brake disks. 4. Check lines for corrosion, chafing and pitting. 6. Check brake system for leaks including hydraulic system. 7. Check free travel of brake pedal. 8. Check handbrake. 9. Check braking action. 2. Check rubber dust caps on wheel and pressure cylinders as well as fixed calipers. Note:

When reconditioning brake system, note the shelf lives and types of storage for rubber components in brake system. Storage Rooms - Types of Storage - Shelf Life Spares for hydraulic brake systems, whether complete assemblies or individual components, whether packed or unpacked, must be carefully stored in the interest of safety. Non-compliance with the instructions concerning. Storage rooms - types of storage - shelf life will normally render the parts unusable. General Essential rubber fittings for hydraulic brake systems such as seals, sealing rings, dust caps and brake hoses, are prone to the effects of heat - oxygen - sunlight - moisture - ozone.

If exposed to such influences when stored, these parts will deteriorate in quality and serviceability to such an extent that they will not be fit for use. Storage Rooms