42.3 Bleeding Brake System Types of Storage Packaged single parts must be left in their packaging until they are needed. Unpackaged parts should be sealed by means of threaded stoppers at open connecting holes. Parts removed from their packaging must be properly closed again for further storage. Brake hoses must be stored on flat surfaces, without strain or stress. This means that they must not be kinked or bent over edges. Brake hoses may be stored in their original packaging U-shaped bend. Rubber fittings such as seals, sealing rings and dust caps require extreme care and must not be deformed by unnecessary loads. This particularly applies to secondary cups and groove seals.
These rubber parts may be stacked in layers one above the other if appropriate storage space is available. Shelf Life Master Cylinders, Tandem Master Cylinders, Wheel Cylinders, Input Cylinders, Output Cylinders 41/2 years Unions and bleeder valves must be tightened and all connection bores sealed with stoppers. Units must be assembled, using the specified protective not brake fluid. Master Cylinders and Tandem Master Cylinders for Brake Boosters may also be stored for years, provided they are obtained as separate assemblies. Brake Pressure Regulators years Brake Booster T 50 2 years Trouble may be expected if this shelf life is exceeded.
Theses boosters may be reconditioned only by the manufacturer and must be returned to us for overhaul at the customer’s expense. Brake Boosters T 51/T 52 Complete with Master or Tandem Master Cylinder years Trouble may be expected if this shelf life is exceeded. The vacuum part cannot be reconditioned and must be scrapped. Vacuum Part for Brake Boosters T 51/T 52 5 years These brake boosters cannot be reconditioned and must be replaced. Brake Hoses, Clutch Hoses years Rubber Fittings loose; stored dry 41/2 years Rubber Fittings in Repair Packs 41/2 years R i P k ith A bl d R bb P t