mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

Bleeding Brake System 42.3 Brake Hoses, General Brake hoses are the moving links in the brake system piping. Any brake hose that is exchanged must be replaced by one of exactly the same length and positioned at exactly the same location. Maintenance After lubricating, ensure that no grease is left on brake hoses. All grease residues should be carefully remo ved. Prior to using sprays containing mineral oil, it is recommended to cover the brake hoses; this should also be done when applying underbody protection. Brake hoses must not be painted. Stove-enamelling or treatment with radiators after painting must not exceed 80 °C. Cleaning Dirt deposits should only be removed with water.

Never use light-grade petroleum, paraffin or similar. Installation The end of new brake hoses must be perfectly clean for installation. Never subject to tension, kinking or torsion, nor allow to chafe. Note maximum wheel lock and spring travel. Tighten screw fittings well. Then refill hydraulic system with fluid and vent. Make absolutely sure that front brake hoses do not touch steering knuckles and do not get pinched when steering wheel is turned.