Bleeding brake system 42.3 Dual-circuit-drum brake Bleeding 1 Raise bonnet. 2 Make bleeder operable according to specifica tions of manufacturer. 3 Unscrew closing cover at expansion tank from circuit I or II and connect bleeder. 4 Remove dust cap at bleeder cylinder. bleed screw and connect 5 Bleed master brake cylinder, as described in 3.4/1. 6 Execute further bleeding in following sequence: Brake circuit I Master brake cylinder, hydropneumatic control valve ALB regulator, wheel brake cylinder, beginning at rear right, rear left, front right, front left. Brake circuit II Master brake cylinder, wheel brake cylinder front right and front left below.