Disassembly and Assembly of Single-Circuit Master Brake Cylinder 42.3 Disassembly and Assembly The Item Nos. relate to p. 1.6/1. 1 Unscrew reservoir. 2 Remove snap ring 1 and stop plate 2, take out piston 5 with secondary cup 3. 3 Remove compression spring 9 together with spring seat 8 and bottom valve 10. 4 Clean and check all parts, replacing if necessary. Note: Never use anything bUt spirit to clean any part. Cleaning with gasoline, benzene or paraffin or with any mineral oil or grease will destroy rubber compo nents or cause them to swell. Rubber components with scored surfaces or flattened edges must be replaced. 5 Assemble in reverse sequence. Note:
Prior to installing, coat cup seals, piston and cylinder bore with brake cylinder paste No. 2.