Disassembling and assembling double wheelbrake cylinder 42.3 Disassembly and assembly 1 Remove wheel brake cylinder. 2 Externally clean wheel brake cylinders. 3 Remove slotted head screw, remove retaining plates. 4 Remove caps of the wheel cylinder housing, remove thrust pin and piston with clotted rings from upper chamber. 5 Unscrew stop screw below with sealing ring. 6 Remove piston below completely from lower chamber of wheel brake cylinder. 7 Remove slotted sleeves of both pistons. 8 Unscrew bleed screws. 9 Clean and check all parts with brake fluid or metholated spirits. Replace damaged parts. 10 Assembly takes place in reverse sequence. Note:
The pistons must move back and forth in dry condition aspirating in the cylinder bore. The edges of the slotted sleeves must be sharp-edged; the bearing surfaces may not show any scoring. Before assem bly, cylinder bore, piston and slotted rings must be provided with ATE-brake cylinder-paste. 11 Install wheel brake cylinder.