. OPERATION MACHINE OPERATIONS AND CONTROLS AFTER STARTING ENGINE WARNING the 3 - 90 If there has been any a bnormal actuation or trouble, tu rn the starting s witch key t o the OF F position Do not carry out operat ions or operate the levers or ped als suddenly whi le the hydraulic oil i s at low te mperature. Alw ays carry out the warm-up opera tion for the hydraulic equipment until the hydrau lic oil temperature monitor is displayed gre If the warm-up operatio n for the hydraulic equipment is not carried out t horoughly , and the machine i s moved, the r eaction of the control levers and pedals will be slow and the mo vement may not be what th e opera tor intende d.
Always wa rm up the hydraulic equipment. I n particular, in cold areas, alway s warm up the h ydraulic e quipmen t thorough There are two types of warm-up operation: warm up the engine an d warm u p the hy draulic e quipment. In addition, depending on the envi ronment, the method of car rying out the warm-up operatio warm-up operation acc ording to the items given in t he appropriate section. (When only the engine is warmed up, the hydraulic equipment is n ot warme d up, s o always carry out the warm-up operation for the hydra ulic equipment separately fro m the warm-up operation for the engine.
Warm up the hydraulic equipment thoroughly ensures that the hydraulic oil is warmed up and that warm hydraulic oil circulates in all the warm h ydraulic oil circulates control circuits.) Breaking-in the New Machine as been thoroughly adjusted and tested before shipment from the factory. However, ope NOTICE Your Komatsu machine h e factory. machine under full load b efore breaking the machine in c an adversely affe ct the performance and shor ten the machin Be sure to break in the m achine for the initial 100 hours (a s indicated on t he service meter).
Make sure that you fully understand the content of thi s manual, and pay caref ul atten tion to the following poi nts when breaking in the machin e. Run the engine at id le for 15 seconds after starti ng it. During th is time, d o not o perate the control leve rs or fuel control dial. minutes after starting it up. heavy loads or at high speeds. Idle the engine for 5 Avoid operation with heavy loads or at high spee Immediately after sta rting the engine, avoid sudde n starts, sudd en acceleration, u nnecess ary sudden st ops, and sudden changes in direction.