. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE NOTICE 4 - 24 Be sure to install the air cleaner element facing in the Install so that the bot tom of the air cleaner element cyl inder (face where no hole is drilled) (B), (C ) is at cover (3) end. If the direc tion of installation is mistaken, there is d element or serious d 8. Replace O-ring (8) of cover (3) with a new p NOTICE When inserting the e lement, if the rubber at the tip is swollen or the outer element is not pushe d in straight, and cover (3) is as sembled by force to hook (2), there is d anger that the hook and air cl ful when assembling. eaner body may be damaged, so be care 9.
Install cover (3 ) as follows. r (3) with the element. ip of hook (2) to the protruding part of the air dy and lock it in position. 1) Align cove 2) Hook the t cleaner bo 3) When locki on opposit as when ti 4) Always ins the ground 5) When cov between th If it is too l ip of hook (2) to the protrud dy and lock it in position. ng hooks (2) in position, appl y the hooks in turn e sides (top, bottom, left, righ t) in the same way ghtening bolts. tall cover (3) so that the evac uator (4) is facing (A). er (3) is installed, check that the clearance e air cleaner body and cover (3) is not too large. arge, install again. 10. Replace seal ( 9) on the cover (3) with a ne