. MAINTENANCE MAINTENANCE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST Checking Adjustment 1. Open engine hood. 2. Remove guard (1). bolts (2) and (3) to hold it in position. NOTICE touching the bottom of the V-groove. A cut or crack is found on the belt. 4 - 44 Press the belt at a point midway between the drive pu lley (B) and compressor pulley (A) with a finger force o f approx. 6 0 N (6.1 kg) (C) and check that the deflection is 6 to 9 mm (0.20 in to 0.40 in). 3. Loosen bolts (2 ) and (3), then move co mpressor ( 4) to adjust. REMARK When the bolts (2) and (3) are loosened, co mpressor (4 ) can move, using the mounting position of bolt (2) as a fulcrum. 4.
When the posi tion of the compressor Check each pulley for damage, wear of the V- groove, and wear of th e V-belt. I n particular, be sure to check that the V-belt is no In case any of the following occurs, ask the Komatsu dist ributor in your territory to replace the bel elongated, leaving little al lowance for adjustment. king sound is heard comin g from the b When the new V-b elt is set, readjust it after o ne hour of o peration.