Komatsu — Komatsu PC308USLC-3E0 Hydraulic Excavator Operation & Maintenance Manual

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE FUEL PRE-FILTER CARTRIDGE WARNING position (S). 4 - 49 After the engine has bee n operated, all parts are at high tem perature, so do not replace the filter im mediately. Wait for all parts to cool down before star ting the operation. ed inside the engine fuel piping system when the engine is running. High pressure is generat ed inside the engine fuel piping s ystem when t When replacing the filter , wait for at least 30 seconds afte r stopping th e engine to let the interna l pressure go down before replacing the filter. lame close.

Do not bring any fire or f NOTICE Genuine Komatsu fuel fi lter cartridges use a special filter that has hig hly efficient filtering ability . When replacing the filter cartridge, always use a g enuine Komatsu part. The common rail fuel inj ection system used on this mach ine consists of more precise parts than the conventional injection pump and nozzle. If any part other than a g enuine Komatsu filter cartridge is used, dust or dirt may get in and cause problems with the injection system. Always avoid u sing substitute parts. When carrying out inspe ction or maintenance of the fuel s ystem, pay m ore attention than normal to the entry of dirt.

If dirt is stuck to any part, use fu el to wash it off completely. Prepare a container to Prepare a filter wrenc 1. Turn the valve (1) at the bottom of the fuel tank to t he CLOSE 2. Open the rear door a t the right of the machine. 3. Set the container to c atch the fuel under the pre-filte r cartridge. 4. Loosen drain valve ( the transparent cap cartridge (4). 2), then drain all the water and (3) and also the fuel accumula sediment in ted in filter 5. Remove connector ( 5). Wrap the removed connect or in a vinyl bag to prevent water 6. Using a filter wrenc from getting on it. h, turn transparent cap (3) to the left to is used again.) remove it. (This cap 7.

Using a filter wrench , turn cartridge (4) to the left to remove it. 8. Install transparent ca p (3) to the bottom of the new filter cartrid (When doing this, al ways replace O-ring (6).)