. MAINTENANCE MAINTENANCE PROCEDURE then let water get on the completely before 14. Turn the valve (1) at the bottom of the fuel tank to the OPEN position (O). 15. After completing the replacement of filter cartridge (4), bleed the air. 18. After finishing to bleed air, push in the knob of feed pump (7) to tighten. 4 - 50 9. When installing, apply oil to the packing sur face and bring the packing surface into contact with the seal su of filter cartridge (4) and then tighten it furt If the transparent cap is tightened too muc is not tightened enough, fuel will leak throu securely to the fixed tightening angle. 10. Clean the filter holder, fill the new filter ca install to the filter holder.
her by 1/4 - 1/2 turns. h, the O-ring will be damaged and this will cause leakage of fue gh the gap at the O-ring. To prevent these problem s, always tig rtridge with clean fuel, coat the packing surface thinly with oil, NOTICE When adding fuel, do not remove cap (B). Alway small holes (A) on the dirty side. After adding fuel, remove cap (B) and install the f Always fill with clean fuel. Be careful not to let an the fuel. In particular, center portion is the clean s cap (B) when adding fuel. Be careful not to let dirt portion on the clean side. 11. When installing, tighten until the packing s urface contacts the seal surface of the filter holder, t hen tighten of a turn.
If the filter cartridge is tightened too far, the filter cartridge is too loose, fuel will also le When tightening with a filter wrench, be packing will be damaged and this will lead to leakage of fuel. ak from the packing, so always tighten the correct a 12. Check that the drain valve (2) is tightened 13. Remove the vinyl bag covering connector REMARK If water gets on the connector (5), the sens and the water separator monitor may light connector (5), be extremely careful not to l connector. If water gets on connector (5), dry it connecting it. Bleed the air as follows: here the float is at the highest position). 16. Fill the fuel tank with fuel (to the position w 17.
Loosen the knob of feed pump (7), pull it o ut, then pump it in and out until the movement becomes heavy REMARK It is not necessary to remove the plug at th After the engine runs out of fuel, use the sa me procedure to operate feed pump (7) and bleed the