Komatsu — Komatsu PC308USLC-3E0 Hydraulic Excavator Operation & Maintenance Manual

. MAINTENANCE MAINTENANCE PROCEDURE pump in grease through the grease fittings shown by arrows. CHECK OIL LEVEL IN SWING MACHINERY CASE, ADD OIL WARNING engine is stopped and may cause serious burns. Wait for the oil 4 - 56 LUBRICATE SWING (2 places) 1. Lower the work equ 2. Using a grease pu 3. After greasing, wip e off any old grease that was pushed out. Parts and oil are at high t emperature immediately after th temperature to go down b efore performing this operation. 1. Open up cover (1) . Oil level gauge (G) is to be found right ) and wipe the oil from the dipstick with a (G) into the filler pipe. behind cover (1). 2. Remove dipstick (G cloth. 3. Fully insert dipstick 4.

Pull out dipstick (G) and check that the oil level is betwe en the (H) and (L) marks o n the dipstick. each the (L) mark on dipstick (G), remove ort (F) and add oil. ) when adding oil. ove the (H) mark on dipstick (G), loosen drain the excess oil. 5. If the oil does not r the cap of oil filler p Remove dipstick (G 6. If the oil level is ab drain valve (P) and Set a container t draining the oil. o catch the oil under drain va lve (P) before 7. After checking oil le vel or adding oil, insert the di pstick ( G) into the hole and install oil filler (F) cap.