. MAINTENANCE MAINTENANCE PROCEDURE CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING 4 - 57 The parts and oil ar e at high temperature imme diately after th e engine is stopped, and may cause s erious burns. Wait fo r the temperature to go d own before starting the op If there is still pres sure remaining inside the c ase, the oil or plug may fly Loosen the plug sl owly to release the pressur Prepare a handle 1. Set the TOP m perpendicular to 2. Remove plug (F ) using the handle. Whe n the oil level reaches a point 10 mm ( 0.4 in) below the bottom hole correct amount of oil has been added. 3. If the oil level i s too low, install plug ( e forward or in reverse levers, and driv one turn.
Then r epeat Step 2 to check a 4. If the oil level is low, add oil through the hole of plug (F). Add oil until oil overf lows from the hole of plu 5. After checking, REMARK There are two plugs (F). Add oil through the one easier to f ill oil and through which no in ternal gears are to be se en.