. MAINTENANCE MAINTENANCE PROCEDURE REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING and may cause burns. Wait for the 4 - 58 EVERY 1000 HOURS MA INTENANCE Maintenance for every 100, 25 0 and 500 hours service should be carried ou t at the same tim The parts and oil are at high temperature to go down before When removing the oil filler cap , turn it slowly to release the internal pressure, the NOTICE f the machine is equipped with a hydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket hydraulic breaker, the hydraulic oil wil operations. For details, see "M maintenance. AINTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-17)" when carrying out 1.
Set the work equipment o n the hard and flat ground in the maintenanceposture as sh ground and stop the engin own in the figure, then lower it to the e. 2. Remove the cap from oil pressure. 3. Loosen 6 bolts, then remo filler (F), and release the internal ve cover (1). When doing this, the he force of spring (2), so hold the g the bolts. nd valve (3), take out element (4). cover may fly out under t cover down when removin 4. After removing spring (2) a Inspect the bottom of the any. Take good care t hydraulic tank. filter case for dirt, and remove it, if hen not to let fall the dirt into the flushing oil. 5. Clean the removed parts in 6.
Install the new element in t he place where old element (4) was installed. ) on top of the element. 7. Set valve (3) and spring (2 8. Set cover (1) in position, p ush it down by hand, and install the cover with the mounting bo lts. nd install the cover. 9. Screw in the oil filler cap a 10. To bleed the air, start the en gine according to "STARTING ENGINE (PAG E 3-87)" and run the engine at low idle for 10 minutes. 11. Stop the engine.