. MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN FINAL DRIVE CASE WARNING 4 - 64 EVERY 2000 HOURS MAINTEN Carry out the per iodic maintenance wo rk of every 100, 25 0, 500 and 100 0 hours of operati on at the same tim The parts and oi l are at high temperature immediately after th e engine is stopp ed, and may cause s erious burns. Wait f or the temperature to g o down before starting the operation If there is still pr essure remaining inside the case, the oil or p lug may fly Loosen the plug slowly to release the pr Refill capacity (each): 8.0 liters (2.1 Prepare a han 1. Set the TOP mark at the top, with the TOP mark and plug (P perpendicula r to the ground surfac e. atch the oil.
handle and drain the oil. 2. Set a contain er under plug (P) to c atch the oil. 3. Remove plug s (P) and (F) with the handle and drain t he oil. REMARK Check the O-ring with new ones. mage. If necessary, replace 4. Tighten plug (P). gh the hole of plug (F). 5. Add oil throu gh the hole of plug (F 6. When oil beg ins to overflow from t he plug (F) h ole, ins tall plug (F). rque of plugs (P) and (F): m (7 ± 1 kgm, 50.6 ± 7.2 lbft) Tightening to rque of plugs (P) and 68.6 ± 9.8 N m (7 ± 1 kgm, 50.6 ± REMARK There are two plu gs (F). Add oil throug h the one easier to f ill oil and through which no internal gears are to be seen.