. MAINTENANCE MAINTENANCE PROCEDURE REPLACE ACCUMULATOR (FOR CONTROL CIRCUIT) WARNING carried out. a to The accumulator is installed to the position shown in the diagram 4 - 72 Replac e the accumulat or every 2 years or every 400 0 hours, wh ichever The acc umulator is charg ed with high-press ure nitrogen ga s, so mistak en operation may cause an exp losion, which will lead to serious injury or damage. When handling the accumulator, always do a s follows. The pressure in the hy draulic circuit cann ot be complete ly removed. When removing the hydraulic equipment, do not stand e direction that the oil spurts out whe n carrying out the operation .
In addition, loosen the bolts slowly when carrying out peration. Do n ot disassemble th Do n ot bring it near fla me or dispose of it Do n ot make holes in it Do n ot hit it, roll it, or s ubject it to any imp Whe n disposing of the accumulator, the gas must be re leased. Plea se contact your Komatsu distr ibutor to have this work If accum ulator has drop remain failure replac ing pressure in on the machine e the accumulato the hydraulic circuit if there should be . Please ask your Komatsu distributor t r. mpossibl e to on the right.