. OPERATION TROUBLESHOOTING TROUBLESHOOTING PROCEDURE FOR BLEEDING AIR CAUTION NOTICE Do not loosen the plug of the fuel pre-filter head. This is at the suction end, so if it is loosened, it will be impossible to bleed the air. a 3 - 153 AFTER RUNNING OUT OF FUEL When starting the en gine again after running o ut of fuel, fill with f uel, then bleed the air from the fuel system before startin g the engine. l level and be careful not to run out of fuel. Alway s watch the fue l level and be careful not to run out of fuel. If the e ngine has stop ped because of lack of fu el, it is necessary t o use the priming pum p to bleed the air co mpletely from t he fuel circuit.
The fuel injection pu mp and nozzle of this engine consist of more precise parts than the conv entional ones. If foreig n matter ente rs them, it can ca use a trouble. Accordingly, if dust sticks to the fue l system, wash it off Whe n opening the ai r bleeding plug at the fuel fil ter head, take care. Fue l may spout because 1. Lo osen air bleed plug (A) at the fuel main 2. Lo osen the wing nut of priming pump (2), c arry out pumping t pu fu mp out the bub bles from air bleed plug el comes out. 3. Ti ghten the air bl ghtening torque : 2.0 to 3.9 Nm {0.2 to 0. 4. Ti ghten the butte rfly nut of the lever of pri 5. Tu rn the key in th e starting switch to the S sta W for at m rt the engine.
hen doing this, do not crank the starting motor continuousl more than 20 s econds. If the engine do es not start, wait fo least 2 minute s, then try again. Perform this operation es. aximum of 4 tim 6. If t he engine doe s not start, repeat the ope ration from Step 1