. MAINTENANCE SERVICE PROCEDURE CLEANING OUTER ELEMENT NOTICE Before and after cleaning the element, do not leave or keep it in direct sunlight. 1. Remove 6 holders (2), then remove cover (3) and take out outer element (4). while pulling it out. 4 - 26 NOTICE Never remove the in ner element (5). It will allow dirt to e nter and cause failure of the engine. river or other tool. Do not use a screwd 2. Hold the outer el ement (4), move it carefully up a nd down and ht, and rotate the element to the left and right 3. After removing t he outer element, cover the air connector inside the air clea dirt or dust from ner body with a clean cloth or ta pe to prevent entering. 4.
Use a brush or cl oth to remove all the dirt stuck to cover (3) and the inside of air c leaner body (6). 5. Direct dry comp ressed air (Max. 0.69 MPa (7 kg/cm2, 99.4 PSI)) from the ins direct the compre again from the in 1) Check that t insert it secu 2) If the yellow diameter imm replace both ide of the outer element along it s folds. Then ssed air from the outside along the folds, and side. he inner element is not loose. If it is loose, rely. piston overlaps the red zone (A) on the outer ediately after the outer eleme nt is cleaned, the inner and outer elements. NOTICE If small holes or thinner parts are found on the element whe n it is checked with an electric bulb afte the element.
ent, do not hit it or beat it against something. whose folds or gasket or seal are damaged. When cleaning the elem ent, do not hit it or beat it against s Do not use an element whose folds or gasket or seal are da