Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK ALTERNATOR CHECKING CHARGE PRESSURE OF NITROGEN GAS IN ACCUMULATOR (FOR CONTROL CIRCUIT) WARNING in the control circuit. Even work equipment to go down The pressure in the hydraulic circuit can be released.

The accumulator is installed to the position shown in the diagram 4 - 78 Cont act your Komatsu distributor to h If the engine is started frequently, ha ve this inspection carried out every CHECK ENGINE VALVE CLEARANCE, Spec ial tools are needed for inspecti on and maintenance, so contact your Komatsu distribu The a ccumulator is charged with high-pre ssure nitrogen gas, so mistaken operation may cause an expl osion, which will lead to seriou s injury or damage. When handling the accumulator, always do as follows. Th e pressure in the hydraulic circuit ca nnot be completely removed.

When removing the hydraulic equipment, do not stand in t the he direction that the oil spurts out w hen carrying out the operation. In addition, loosen the bolts s lowly when carrying out operation. not disassemble the accumulator. f it in fire. mpact. Do Do not bring it near flame or dispose o Do not make holes in it or weld it. Do not hit it, roll it, or subject it to any i Wh en disposing of the accumulator, t he gas must be released. Please contact your Komatsu distr ibutor to have this work car ried out.

NOTIC E If the nitrogen gas charge pressure in the accumulator is low and operations are continued, it will beco me impossible to release the re maining pressure inside the hydraul ic circuit if a failure occurs on the machine. FUNCTION OF ACCUMULATOR The accumulator stores the pressure after the fo the engine is stopped, the contr llowing actions are possible. If t eq un he control lever is operated in th uipment, it is possible for the der its own weight. on th e right.