. MAINTENANCE SERVICE PROCEDURE following manner. ADJUSTMENT WARNING 4 - 27 CHECK TRACK SHOE TEN The wear of pins and bushings on the undercarriage will vary with the working conditions a nd types of soil. It is thus necessar y to continually inspec t the track tension so as to maintain the standard tension. Carry out the check and adjus tment under the same co nditions as becomes clogged with mud, m easure with the track clog ged with INSPECTI ON machine on level ground (stop with the transmission in Stop the FORWAR D without applying th e brake).
Then place a st raight bar on the tra ck shoes between the carrier roller and the idler as shown in the figu grouser a re, and measure the t the midpoint. If the cl clearance between the ba earance (a) is 20 to 30 m r and the m (0.79 to 1.18 in), t If the tra he tension is standar ck tension is not at th d. e standard value, adjust it in the There is da nger of plug (1) flying ou t under the high internal pres sure of the grease. N ever loosen plug (1) mor e than 1 turn. plug (1). Never put your face in the sened with the procedure given here, butor. Never loos en any part other than mounting direction of plug (1).
k tension cannot be loo If the trac please con tact your Komatsu distri WHEN INCREASING TENSION Prepare a grease pump. 1. Remove cover (3) and pum (2) with a grease pump. 2. To check that the correct te machine backwards and fo 3. Check the track tension aga adjust it again. p in grease through grease fitting Prepare a 1. Rem (2) wi 2. To ch mach 3. Chec adjus 1. Rem th a grease pump. 2. To ch eck that the correct te nsion has been achieved, move the ine backwards and fo rwards. 3. Chec k the track tension aga in, and if the tension is no t correct, t it again. NOTICE The saf ety label is stuck on the back of cover (3), so be car eful not to damage the safety label.
reful not to let any dirt or soil get in. When r emoving cover (3), be ca reful not to let any dirt or soi