. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN DAMPER CASE WARNING 4 - 88 temperature d rops, then start the work. The undercov cover when di er is heavy (22 kg (49 lb)). Never rectly beneath it. When removin try to open or close the g bolts (2), carry out the work from the rear of the cover so that you can easily get out of the way. When removin oil over yours Refill capaci 1. Remove th e undercover from the rear bottom of the machine lows. e two bolts (1) from the front side of the machine body as fol 1) Remov body. 2) Holding of the m 3) Lower (A) Fro (B) Dan the cover, remove two bolts (2) from the rear side achine body. . and open the cover gradually nt of machine gerous place 2.
Remove oi l level plug (3) and oil filler plug (4), then remove drain plug ( plug (5). 5) to drain the oil. After the a ll oil is drained, tighten ugh the hole of oil filler plug (4) until the oil level e bottom edge of the hole of oil level plug (3). g the oil, tighten plugs (3) and (4). 3. Add oil thro reaches th e bottom edge of the hole of 4. After refillin g the oil, tighten plugs (3) an