Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 07 (PTO HOUSING AND MAGNETO) STARTER DRIVE If any part of the assembly shows signs of ab- normal wear, cracks, broken teeth or malfunction (sprag clutch), replace the faulty part. Starter Drive Removal Remove the PTO housing and ring gear as de- scribed in this subsection. Remove starter drive assembly. Starter Drive Installation For installation, reverse the removal procedure. However, pay attention to the following. NOTE: When installing a new starter drive assem- bly, oil the shaft, gear teeth and splines with en- gine oil. Apply ISOFLEX GREASE TOPAS NB 52 (P/N 293 550 021) on the starter drive bearing located in the cylinder block and in the PTO housing. 1.

Starter drive assembly NOTICE Be careful not to lose the disc springs and thrust washer located on the starter drive shaft. 1. Starter drive bearing (cylinder block) smr2005-034-002_a 1. Disc springs 2. Thrust washer 3. Starter drive gear smr2009-022-009_a 1. Starter drive bearing (PTO housing) NOTICE Be sure not to forget the disc springs and washer on the starter drive shaft when re- assembling. Starter Drive Inspection Inspect all starter drive parts for excessive wear, cracks and other defects. Pay attention to the condition of the drive gear teeth. Ensure proper operation of the starter drive sprag clutch. smr2009-022 83