Section 02 ENGINE Subsection 07 (PTO HOUSING AND MAGNETO) TYPICAL 1. Magneto rotor retaining screws 2. Rotor 3. Trigger wheel 4. Ring gear TYPICAL 1. Rotor retaining screws 2. Rotor 3. Trigger wheel Ring Gear Inspection Inspect ring gear for damages. Pay particular at- tention to teeth condition. If badly worn, cracked, or broken teeth are found, replace ring gear. Rotor and Trigger Wheel Installation For installation, reverse the removal procedure. However, pay attention to the following. Align the trigger wheel to the crankshaft using the location pin on the crankshaft end. Install NEW OEM rotor screws and torque them to 15 N•m (133 lbf• in ) using a crisscross pattern.
Finish tightening screws with an additional 50° ro- tation with a torque angle gauge. Ring Gear Installation For installation, reverse the removal procedure. However, pay attention to the following. Align the ring gear and trigger wheel to the crank- shaft using the location pin on the crankshaft end. NOTICE Always install NEW OEM screws with pre-applied threadlocker. These are stretch screws that are one time use only. Not replacing rotor screws may lead to engine damage and failure. RING GEAR Ring Gear Removal Lock crankshaft. Refer to CYLINDER BLOCK sub- section for procedure. Remove the PTO housing cover, see procedure in this subsection.
Remove and discard the magneto rotor retaining screws. Pull rotor and trigger wheel off crankshaft end. Pull rotor, trigger wheel, and ring gear off crank- shaft end. TYPICAL 1. Location pin 2. Location pin holes Install NEW OEM rotor screws and torque them to 15 N•m (133 lbf• in ) in a crisscross pattern. Finish tightening screws with an additional 50° ro- tation with a torque angle gauge. NOTICE Always install NEW OEM screws with pre-applied threadlocker. These are stretch screws that are one time use only. Not replacing rotor screws may lead to engine damage and failure. 82 smr2009-022