Section 02 ENGINE Subsection 07 (PTO HOUSING AND MAGNETO) Recheck reading on reference tooth to ensure gauge has not changed position (gauge should still read zero). NOTE: The maximum allowable difference be- tween teeth is 0.15 mm (.006 in). If the reading exceeds the maximum allowable difference, straighten the tooth or replace the trigger wheel. smr2009-022-009_b TYPICAL 1. Stator cable grommet Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on the stator screw threads and stator cable holding plate screw threads. Torque stator and cable holding plate screws to 9 N•m (80 lbf• in ). Install PTO housing as per procedures in this sub- section. smr2009-022-015_a 1. Trigger wheel 2.
Dial indicator ROTOR AND TRIGGER WHEEL Rotor and Trigger Wheel Inspection Inspect rotor and trigger wheel condition. Pay particular attention to the inside of the rotor for cracks, rub marks or discoloration. If damaged, replace faulty part. Check the trigger wheel for bent teeth using the following procedure. Install a dial indicator on crankcase casting. Position the gauge on a tooth and set it to zero (0). Be sure to lock the indicator dial to prevent movement of the dial during the remainder of the procedure. Draw a line on the tooth to indicate it as the first tooth measured (reference tooth). Gently lift the gauge contact point off the tooth and rotate the flywheel to the next tooth.
NOTE: When lifting contact point off the tooth for flywheel rotation, be careful not to move gauge position or test readings taken on next tooth will not be accurate with reference to the reference tooth. Gently set the gauge contact point on the next tooth and read the dial indicator. Repeat this procedure taking a reading at each tooth. Properly reinstall cover. Rotor and Trigger Wheel Removal Lock crankshaft, refer to CYLINDER BLOCK sub- section for procedure. Remove PTO housing, see procedure in this sub- section. Remove and discard the magneto rotor retaining screws. Pull rotor and trigger wheel off crankshaft end. smr2009-022 81