Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) GENERAL During assembly/installation, use torque values and service products as in the exploded views. Clean threads before applying a threadlocker. Re- fer to SELF-LOCKING FASTENERS and LOCTITE APPLICATION at the beginning of this manual for complete procedure. WARNING Torque wrench tightening specifications must be strictly adhered to. Locking devices (e.g.: locking tabs, elastic stop nuts, self-locking fasteners, cotter pins, etc.) must be replaced with new ones. smo2009-002-003_b 1. Oil dipstick Hoses, cables or locking ties removed during a procedure must be reinstalled as per factory stan- dards. Check the oil level as follows: NOTE:

It is of the utmost importance to follow this procedure in order to obtain an accurate read- ing of the engine oil level. 1. Watercraft must be level. Check oil level either with watercraft in water or out of water. 2. If the watercraft is out of water, link a garden hose to the hose adapter. Refer to EXHAUST SYSTEM FLUSHING in the EXHAUST SYSTEM subsection. MAINTENANCE ENGINE OIL Recommended Oil Use XPS SUMMER GRADE OIL (P/N 293 600 121) . If XPS TM engine oil is not available, use a 10W40 mineral engine oil compatible with wet clutches. NOTE: The XPS engine oil has been thoroughly tested to be free of any additives that could impair the functionality of the supercharger clutch.

NOTICE When watercraft is out of water: Never run engine without supplying water to the exhaust system. Never run engine longer than 2 minutes. Drive line seal has no cooling when water- craft is out of water. NOTICE NEVER use synthetic oil. This would impair the proper operation of the super- charger clutch. Do not add any additives to the recommended oil. Mineral oils not recom- mended by BRP may also contain additives (friction modifiers) that may cause inappropri- ate slippage of the supercharger and eventu- ally lead to premature wear. For this reason, XPS Summer Grade oil or a BRP approved equivalent are the only recommended oils.

Use of any oil not recommended by BRP may void BRP's limited warranty. 3. Warm-up engine then let idle for 30 seconds before stopping. 4. Stop engine. 5. Open seat and remove the ventilation box from the deck extension to gain partial access to en- gine compartment. NOTE: To remove the rear ventilation box, simply release the 3 clips retaining it and lift it off the deck extension. Oil Level Verification NOTICE Check level frequently and refill if necessary. Do not overfill it would make the engine smoke and reduce its power. Op- erating the engine with an improper level may severely damage engine. Wipe off any spillage. 90 smr2009-023