Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) lmr2007-053-100_a 1. Full 2. Add 3. Operating range Otherwise, add oil until its level is between marks as required. To add oil, unscrew oil cap. Place a funnel into the oil filler neck opening and add the recommended oil to the proper level. Do not overfill. smo2009-002-002_a 1. Rear ventilation box 2. Deck extension 3. Retaining clips Oil Change NOTE: Oil and oil filter must be replaced at the same time. Oil change and oil filter replacement should be done with a warm engine. Bring engine to its normal operating temperature. 6. Wait at least 30 seconds for the oil to settle in the engine, then pull dipstick out and wipe clean.

WARNING Engine oil may be hot. Certain components in the engine compartment may be very hot. Direct contact may result in skin burn. NOTICE When watercraft is out of water: Never run engine without supplying water to the exhaust system. Never run engine longer than 2 minutes. Drive line seal has no cooling when water- craft is out of water. Run engine for 10 seconds at 4000 RPM and shut it off at this RPM. This will move oil from PTO housing to oil tank to allow maximum oil draining. Remove oil filler cap and dipstick. WARNING Engine oil may be hot. Certain components in the engine compartment may be very hot. Direct contact may result in skin burn.

Using the SUCTION PUMP (P/N 529 035 880) , siphon oil through dipstick hole. smo2009-002-003_b 1. Oil dipstick 7. Reinstall dipstick, push in completely. 8. Remove dipstick and read oil level. It should be between the FULL and ADD marks. 529035880 smr2009-023 91