Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) NOTICE Never crank or start engine when suction pump tube is in dipstick hole. Never start engine when there is no oil in engine. NOTE: So that suction pump tube is located at the proper height to siphon oil, it is suggested to put some electrical tape on tube at 475 mm (18-11/16 in) from its end. Then, insert the tube until you reach the tape. smr2009-023-003_a 1. Oil filter screw 2. Oil filter cover 3. Oil filter NOTE: No tools are required to remove the oil fil- ter cover, as it will pull off when the oil filter screw is unscrewed. Place rags in filler area to prevent spillage.

If spillage occurs, clean immediately with the PUL- LEY FLANGE CLEANER (P/N 413 711 809) to prevent stains. Oil Filter Inspection Check oil filter cover O-rings and oil filter screw O-ring, change if necessary. Check and clean the oil filter inlet and outlet area for dirt and other contaminations. TYPICAL 1. Suction pump 2. Suction pump tube in dipstick hole Pull suction pump tube out of dipstick hole then crank engine (do not start) while in engine drown mode (fully depress throttle lever and HOLD, then crank engine). Crank engine for 10 seconds. Siphon oil again. Repeat the crank-siphon cycle 2 - 3 times. Refill engine with the recommended oil, see REC- OMMENDED OIL in this subsection.

Reinstall oil filler cap and dipstick. Replace OIL FILTER, see procedure in this sub- section. smr2009-023-004_a 1. Inlet bore from the oil pump to the oil filter 2. Outlet bore to the engine oil providing system OIL FILTER Oil Filter Removal Remove: Oil filter screw Oil filter cover Oil filter. Oil Filter Installation For installation, reverse the removal procedure. Pay attention to the following details. Install a NEW oil filter. Install O-ring on oil filter cover. 92 smr2009-023