Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) Apply engine oil on filter ring, filter cover O-rings and on oil filter screw O-ring. NOTE: In salt water area, it is recommended to coat mating surface of cover with SUPER LUBE GREASE (P/N 293 550 030) . Torque oil filter screw to 9 N•m (80 lbf• in ). INSPECTION 529035652 ENGINE OIL PRESSURE Use the following table to compare the oil pres- sure at different RPM. NOTE: Depending on the oil pressure switch, the threshold value to send a signal of low oil pressure may vary from a minimum of 180 kPa (26 PSI) to a maximum of 220 kPa (32 PSI). Bring engine to its normal operating temperature.
WARNING Certain components in the engine compart- ment may be very hot. Direct contact may re- sult in skin burn. Test at the Oil Pressure Switch Location Remove oil pressure switch and install gauge. NOTICE When watercraft is out of water: Never run engine without supplying water to the exhaust system. Never run engine longer than 2 minutes. Drive line seal has no cooling when water- craft is out of water. The oil pressure is measured using the PRESSURE GAUGE (P/N 529 035 709) and the ADAPTER HOSE (P/N 529 035 652) . A 1/8 NPT pipe extension may ease the installation. smr2009-023-005_a INSTALLATION AT PRESSURE SWITCH LOCATION 1.
Remove oil pressure switch and install gauge here To prevent the EMS to go in limp home mode (at 2500 RPM) or to generate a fault code, do the fol- lowing: 1. Ground OPS to engine. 2. Plug OPS to harness. 3. Start engine. 4. While engine is running, unplug OPS from har- ness. Read oil pressure at different RPM as per table above. 529035709 smr2009-023 93 OIL PRESSURE Idle (cold) 448 kPa - 648 kPa (65 PSI - 94 PSI) for a very short time Idle (at 80°C (176°F)) Min. 228 kPa (33 PSI) 4000 - 7500 400 kPa - 496 kPa (58 PSI - 72 PSI)