Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) Reinstall oil pressure switch. 4. Oil pressure regulator valve sticks open, or spring load is too small. - Clean oil regulator piston and its bore. Replace if necessary. - Measure spring free length. Replace if too small. Test at the Cylinder Head Location The oil pressure may be measured from cylinder head if desired. Remove plug located on cylinder head and install gauge. 5. Oil pump(s) worn or damaged. - Check oil pump rotors and its bore for wear limits. Replace if out of specification. 6. Engine oil strainers are clogged. - Remove and clean engine oil strainers. 7. Heavy wear on plain bearings.

- Check radial clearance of plain bearings. Replace if out of specification. HIGH OIL CONSUMPTION 1. Oil in breathing system. - Check if breather V-ring is brittle, hard or dam- aged. Replace V-ring. 2. Valve stem seals worn or damaged. - Replace valve stem seals. smr2009-023-006_a INSTALLATION AT CYLINDER HEAD 1. Remove plug and install gauge here 3. Piston rings worn out (blue colored exhaust smoke). - Replace piston rings. Start engine and read pressure at different RPM as per table above. Reinstall plug. OIL CONTAMINATION (WHITE APPEARANCE) TROUBLESHOOTING 1. Oil seal and rotary seal on water pump shaft leaking. - Replace oil seal and water pump shaft assembly.

- Change engine oil and oil filter. The following is provided to help in diagnosing the probable source of troubles. It is a guideline and it should not be assumed to list all possible prob- lems. Always check for fault codes. If a fault code is de- tected, service the fault code first. Refer to EN- GINE MANAGEMENT section. 2. Cylinder head gasket leaking. - Replace cylinder head gasket and tighten cylinder head with recommended torque. - Change engine oil and oil filter. 3. Cylinder head screws not properly tightened. - Retighten screws with recommended torque. - Change engine oil. LOW OR NO ENGINE OIL PRESSURE 1. Oil level too low. - Refill engine oil. - Check for high oil consumption.

See below. - Check for oil leaks (oil leaking out of leak indica- tor hole, gaskets, oil seal or O-rings). Repair or replace. 4. Oil cooler O-rings are leaking. - Replace O-rings. - Change engine oil and oil filter. 5. Cylinder block or cylinder head casting is leak- ing. - Check for internal cracks in casting. Replace dam- aged components. - Change engine oil and oil filter. 2. Oil pressure switch defective. - Check and replace if necessary. 3. Oil filter clogged. - Replace engine oil and oil filter at the same time. 94 smr2009-023