Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) PROCEDURES OIL PRESSURE SWITCH (OPS) Oil Pressure Switch Operation The oil pressure switch activates if engine oil pressure falls between 180 kPa and 220 kPa (26 PSI and 32 PSI). smr2009-023-102_a If resistance values are incorrect, replace OPS. If the values are correct, check the continuity of the wiring harness. smr2009-023-005_a 1. OPS Oil Pressure Switch Inspection First, carefully check the condition of the connec- tor terminals. Clean to remove dirt and corrosion that could affect proper operation of the OPS. IMPORTANT: Do not apply dielectric grease on terminal.
Before checking the function of the OPS, an oil pressure test has to be performed to be sure the oil pressure is not in fault. Refer to INSPECTION in this subsection. When the engine oil pressure tests good but the OIL message in the information center is present and the beeper sounds: Ensure OPS connector is plugged to the switch. Check the resistance of the OPS while engine is off and while engine is running. Oil Pressure Switch Circuit Continuity Test Disconnect the ECM connector A from the ECM. Use the ECM ADAPTER TOOL (P/N 529 036 166) and a multimeter. 529036166 Oil Pressure Switch Resistance Test Disconnect the connector from the OPS. Use a multimeter to check the resistance as shown.
Check continuity of OPS circuit as per following table. smr2009-023 95 ENGINE RUNNING TEST PROBES RESISTANCE ( ) OPS connector (pin 1) Engine ground Infinitely high (OL) when pressure reaches 180 kPa (26.11 PSI) and 220 kPa (32 PSI) ENGINE NOT RUNNING TEST PROBES RESISTANCE ( ) OPS connector (pin 1) Engine ground Close to 0 (normally closed switch)