Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) PTO OIL STRAINER NOTE: The oil strainer does not need to be cleaned at every oil change. Clean it during other inspections, especially when the engine is disas- sembled. PTO Oil Strainer Removal Remove engine oil. See procedure in OIL CHANGE in this subsection. Remove the PTO housing. Refer to PTO HOUS- ING AND MAGNETO subsection. Remove the oil strainer. If continuity test failed, repair or replace the con- nector and wiring between ECM connector and OPS. If continuity test succeeded, check the ECM. Re- fer to EFI subsection. smr2009-023-102_b Oil Pressure Switch Removal Remove the throttle body.

Refer to ELECTRONIC FUEL INJECTION (EFI) subsection. Unplug the OPS connector. Unscrew and remove the oil pressure switch. 1. PTO oil strainer 8 9 PTO Oil Strainer Cleaning and Inspection Clean oil strainer with a part cleaner then use an air gun to dry it. Check and clean the oil outlet area for dirt and other contaminations. smr2009-023-005_a 1. OPS Oil Pressure Switch Installation Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on threads of oil pressure switch. Torque oil pressure switch to 9 N•m (80 lbf• in ). 96 smr2009-023 OPS CONNECTOR ECM ADAPTER RESISTANCE Pin 1 Pin E3 Close to 0 (continuity)