Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) 1. Oil inlet to the oil pump smr2006-014-022_a 1. Oil strainer 2. Suction pump cover PTO Oil Strainer Installation For installation, reverse the removal procedure. However, pay attention to the following. Clean cylinder block to remove all remaining sili- cone residues in oil strainer area. Apply a thin layer of LOCTITE 5910 (P/N 293 800 081) on oil strainer side. Install it in the PTO housing. Install the PTO housing using the procedure de- scribed in the PTO HOUSING AND MAGNETO subsection. Refill engine at the proper level with the recom- mended oil. Refer to ENGINE OIL for the proce- dure.

Suction Pump Oil Strainer Cleaning and Inspection Clean oil strainer with a part cleaner then use an air gun to dry it. Inspect rubber ring gaskets. SUCTION PUMP OIL STRAINER NOTE: The oil strainer does not need to be cleaned at every oil change. Clean it during other inspections, especially when the engine is disas- sembled. Suction Pump Oil Strainer Removal Remove oil filler tube and suction pump cover, re- fer to OIL SUCTION PUMP in this subsection. Remove oil strainer from the suction pump cover. smr2006-014-020_a 1. Suction pump cover gasket 2. Oil filler tube gasket If rubber rings are brittle, cracked or hard, replace them. Clean both contact surfaces of oil suction pump cover.

Check and clean the oil inlet and outlet area for dirt and other contaminations. smr2009-023 97