Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) smr2009-023-007_a 1. Oil inlet 2. Oil outlet smr2009-023-009_a TIGHTENING SEQUENCE Suction Pump Oil Strainer Installation For installation, reverse the removal procedure. However, pay attention to the following. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on threads of the suction pump cover screws and tighten them to 9 N•m (80 lbf• in ). Position screws according to their length as shown. ENGINE OIL PRESSURE REGULATOR The oil pressure regulator is located on the bottom of the PTO housing. smr2007-015-005_a TYPICAL 1. Oil pressure regulator NOTE: The oil pressure regulator system opens when the oil pressure exceeds 400 kPa (58 PSI).
smr2009-023-008_a 1. Screws M6 x 25 2. Screws stainless steel M6 x 45 Torque suction pump cover screws as per se- quence illustrated below. Oil Pressure Regulator Removal Remove engine oil. See procedure in OIL CHANGE in this subsection. Remove: Oil pressure regulator plug Compression spring Valve piston Valve piston guide. 98 smr2009-023