Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) Oil Pressure Pump Removal 1. Remove engine oil. See procedure in OIL CHANGE in this subsection. 2. Remove the PTO housing. Refer to PTO HOUSING AND MAGNETO subsection. 3. Remove water pump housing and the impeller. Refer to COOLING SYSTEM subsection. 4. Remove screws securing the oil pump cover. smr2007-015-005_b TYPICAL 1. Valve piston guide 2. Valve piston 3. Compression spring 4. Oil pressure regulator plug 5. O-ring WARNING Oil pressure regulator plug on oil pump hous- ing is spring loaded. Oil Pressure Regulator Inspection Inspect valve piston and valve piston guide for scoring or other damages.

Check compression spring for free length. 1. Screws 2. Oil pump cover 5. Pull and remove the outer oil pump rotor. Replace parts if important wear or damage are present. Clean bore and threads in the PTO housing from metal shavings and other contaminations. Oil Pressure Regulator Installation For installation, reverse the removal procedure. Pay attention to the following details. Be careful that the O-ring on plug screw is in place. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on threads of the oil pressure regulator plug. Torque plug screw to 13 N•m (115 lbf• in ). 1. Outer oil pump rotor OIL PRESSURE PUMP 6.

Refer to COOLING SYSTEM subsection and ex- tract the water/oil pump shaft from outside PTO housing. 7. Using a screwdriver, remove the rotary seal. The oil pressure pump is located in the PTO hous- ing and is driven by the balance shaft. smr2009-023 99 COMPRESSION SPRING FREE LENGTH NEW NOMINAL 58.2 mm (2.291 in) SERVICE LIMIT 50.3 mm (1.98 in)