Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) 1. Pittings on the teeth Using a feeler gauge, measure the clearance be- tween inner and outer rotors. TYPICAL NOTICE Be careful not to damage the surface of the rotary seal bore in PTO housing cover. 8. Remove and discard the oil seal behind rotary seal. 1. Outer rotor 2. Inner rotor 1. Oil seal Oil Pressure Pump Inspection Inspect oil pump shaft, housing and cover for marks or other damages. Check inner rotor for corrosion pin-holes or other damages. If so, replace oil pump shaft. Ensure to also check oil pump housing and cover and re- place if damaged.

If clearance between inner and outer rotors ex- ceeds the tolerance, replace water/oil pump shaft. Ensure to also check oil pump housing and cover and replace if damaged. If clearance between outer rotor and its bore in oil pump exceeds the tolerance, replace the com- plete oil pump and the PTO housing. Using a vernier depth gauge, measure side wear as shown. 100 smr2009-023 OUTER AND INNER ROTOR CLEARANCE SERVICE LIMIT A 0.25 mm (.0098 in) B C