Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) 1. PTO housing surface 2. Vernier depth gauge 1. Oil seal Install the new rotary seal by using the WATER PUMP SEAL PUSHER (P/N 529 035 823) . 529035823 NOTICE Never use a hammer for the rotary seal or water/oil pump shaft installation. Only use a press to avoid damaging the ceramic component. 1. Oil pump outer rotor surface 2. Vernier depth gage Difference between pump housing and outer ro- tor should not exceed 0.1 mm (.004 in). If so, re- place the complete oil pump assembly. NOTE: When the axial clearance of the oil pump shaft increases, the oil pressure decreases.

Check the inside of oil pump housing and its cover for scoring or other damages and replace if dam- aged. Oil Pressure Pump Installation For installation, reverse the removal procedure. Pay attention to the following details. NOTE: Never use oil in the press fit area of the rotary seal. Push water/oil pump shaft oil seal in place by us- ing thumb. TYPICAL 1. Rotary seal 2. Rotary seal pusher Install the OIL SEAL GUIDE (P/N 529 035 822) on the end of coolant/oil pump shaft. smr2009-023 101