Section 02 ENGINE Subsection 08 (LUBRICATION SYSTEM) 3. Remove the air intake silencer. Refer to AIR IN- TAKE SYSTEM subsection. 4. Detach the muffler from the exhaust manifold and move muffler backwards. Refer to EX- HAUST SYSTEM subsection. 5. Remove engine support mount screws. 6. Move engine backwards, just enough to reach oil suction pump cover screws. 7. Remove retaining screws from oil filler tube. 1. Oil seal guide 2. Water/oil pump shaft Using the WATER PUMP SEAL PUSHER (P/N 529 035 823) to support the PTO cover, install the coolant/oil pump shaft. smr2009-023-010_a 1. Oil filler tube screws 8. Remove oil filler tube. 9. Remove retaining screws. 1.
Water/oil pump shaft with oil seal guide 2. Rotary seal pusher Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on threads of oil pump cover screws. Tighten oil pump cover screws and torque to 9 N•m (80 lbf• in ). After engine is completely reassembled, start en- gine and make sure oil pressure is within specifi- cations. OIL SUCTION PUMP smr2009-023-011_a 1. Suction pump cover screws The oil suction pump is located on the front side of the engine inside of the oil suction pump housing at the bottom of the oil filler tube. 10. Place rags under cover to prevent spillage. If spillage occurs, clean with the PULLEY FLANGE CLEANER (P/N 413 711 809) . 11. Remove the oil suction pump housing. 12.
Remove oil pump screws and cover. Oil Suction Pump Removal 1. Remove jet pump and drive shaft. Refer to STEERING AND PROPULSION section. 2. Remove the moving deck. Refer to BODY sub- section. 102 smr2009-023